Toyota Corolla (E210) 2019-2026 Owners Manual
Toyota Corolla (E210) 2019-2026 Owners Manual
- Pictorial index
- For safety and security
- Vehicle status information and indicators
- Warning lights and indicators
- Gauges and meters (4.2-inch display)
- Gauges and meters (7-inch display)
- Multi-information display (4.2-inch display)
- Multi-information display (7-inch display)
- Fuel consumption information
- Before driving
- Key information
- Opening, closing and locking the doors
- Adjusting the seats
- Adjusting the steering wheel and mirrors
- Opening and closing the windows
- Favorite settings
- Driving
- Before driving
- Driving procedures
- Operating the lights and wipers
- Refueling
- Using the driving support systems
- Driving tips
- Interior features
- Using the air conditioning system and defogger
- Using the interior lights
- Using the storage features
- Other interior features
- Maintenance and care
- Cleaning and protecting the vehicle exterior
- Cleaning and protecting the vehicle interior
- Maintenance requirements
- General maintenance
- Emission inspection and maintenance (I/M) programs
- Do-it-yourself service precautions
- Hood
- Positioning a floor jack
- Engine compartment
- Tires
- Tire inflation pressure
- Wheels
- Air conditioning filter
- Wireless remote control/electronic key battery
- Checking and replacing fuses
- Headlight aim (vehicles with front side marker lights [bulb type] )
- Light bulbs
- When trouble arises
- Vehicle specifications
Other materials:
Basic repair hint
(A) hints on operations
1
Looks
Always wear a clean uniform.
Hat and safety shoes must be worn.
2
Vehicle protection
Set a grill cover, fender cover, seat cover and floor mat before
starting the operation.
3
Safe ...
Inspection procedure
1 Check p/t squib(rh) circuit(airbaga sensor assy center – front
seat outer belt assy rh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensi ...
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...