Toyota Corolla (E210): Driving
- Before driving
- Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Engine (ignition) switch (vehicles with a smart key system)
- Changing engine switch modes
- Continuously variable transmission (vehicles without paddle shift switches)
- Continuously variable transmission (vehicles with paddle shift switches)
- Selecting shift ranges in the D position
- Changing gears in the M position
- Turn signal lever
- Parking brake
- Brake Hold
- Operating the lights and wipers
- Refueling
- Using the driving support systems
- Toyota Safety Sense 3.0 software update
- Toyota Safety Sense 3.0
- PCS (Pre-Collision System)
- LTA (Lane Tracing Assist)
- LDA (Lane Departure Alert)
- PDA (Proactive driving assist)
- RSA (Road Sign Assist)
- Dynamic radar cruise control
- Using the dynamic radar cruise control
- Cruise control
- Emergency Driving Stop System
- BSM (Blind Spot Monitor)
- Blind Spot Monitor operation
- RCTA (Rear Cross Traffic Alert) function
- RCTA function
- Safe Exit Assist
- Driving mode select switch
- Driving assist systems
- Driving tips
Other materials:
Circuit description
Shifting from 1st to o/d is performed in combination with on and off of the
shift solenoid valve s1 and s2
controlled by ecm. If an open or short circuit occurs in either of the solenoid
valves, the ecm controls the
remaining normal solenoid valve to allow the vehicle to be operated smoothly
...
Adjustment
1. Check and adjust brake pedal height
Inspect brake pedal height.
Pedal height from asphalt sheet:
m/t: 134.9 – 144.9 Mm (5.311 – 5.703 In.)
A/t: 136.0 – 146.0 Mm (5.353 – 5.747 In.)
Disconnect the connector from the stop lamp
switch.
Remove the stop lamp ...
Overhaul
1. Remove speedometer drive (mtm) gear
Remove the speedometer drive (mtm) gear from the front
differential case.
2. Remove front differential ring gear
Place matchmarks on the front differential ring gear and
front differential case.
Remove the 8 bolts. Using a hamme ...