Toyota Corolla (E210): Windshield wipers and washer

Operating the lever can use the windshield wipers or the washer.

NOTICE

■When the windshield is dry

Do not use the wipers, as they may damage the windshield.

Operating the wiper lever

Operating thethe wipers or washer as follows. lever operates the wipers or washer as follows.

  1. (Canada) (U.S.A.) or Intermittent windshield wiper (Canada) Intermittent windshield wiper operation
  2. (Canada) (U.S.A.) or Low speed windshield wiper operation (Canada) Low speed windshield wiper operation
  3. (Canada) (U.S.A.) or High speed windshield wiper (Canada) High speed windshield wiper operation
  4. (Canada) (U.S.A.) or Temporary operation (Canada) Temporary operation

  1. operation Washer/wiper dual operation

Pulling the lever operates the wipers and washer.

Wipers will automatically operate a couple of times after the washer squirts.

Interval adjustment type only: Wiper intervals can be adjusted when intermittent operation is selected.

  1. Increases the intermittent windshield wiper frequency
  2. Decreases the intermittent windshield wiper frequency

■The windshield wiper and washer can be operated when

The engine switch is in ON.

■If no windshield washer fluid sprays

Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir.

■When stopping the engine in an emergency while driving

If the windshield wipers are operating when the engine is stopped, the windshield wipers will operate in high speed operation. After the vehicle is stopped, operation will return to normal when the engine switch is turned to ON.

WARNING

■Caution regarding the use of washer fluid

When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.

NOTICE

■When the washer fluid tank is empty

Do not operate the switch continually as the washer fluid pump may overheat.

■When a nozzle becomes blocked

In this case, contact your Toyota dealer. Do not try to clear it with a pin or other object. The nozzle will be damaged.

    Share this page:

    Other materials:

    Pre–check
    1. Selecting compass display mode  the compass switch allows you to select the display or non–display mode of the compass. 2. Setting zone  deviation between the ”magnetic north” and ”actual north” differs depending on the location. Therefore, adjustment of the ...

    General information
    There are many ecu controlled systems used in the corolla. In general, ecu controlled system are considered to be very intricate and require a high level of technical knowledge and expert skill to troubleshoot. The fact is, however, that if you proceed by inspecting the circuits one by one, ...

    Steering wheel audio switches
    Some audio features can be controlled using the switches on the steering wheel. Operation may differ depending on the type of multimedia system or navigation system. For details, refer to the manual provided with the multimedia system or navigation system. Operating the multimedia system using ...