Toyota Corolla (E210) 2019-2026 Owners Manual

Toyota Corolla (E210) 2019-2026 Owners Manual

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Pre–check
1. Srs warning light check Turn the ignition switch to the on position and check that the srs warning light lights up. check that the srs warning light goes out after approx. 6 Seconds. Hint: when the ignition switch is at on and the srs warning light remains on or flashes, the ...

If the engine will not start
If the engine will not start even though correct starting procedures are being followed, consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be sufficient fuel in the ...