Toyota Corolla (E210): Before driving

Share this page:

Other materials:

On–vehicle inspection
1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

Inspection procedure
1 Check operation(stop lamp swtich assy) Check that the stop light comes on when the brake pedal is depressed, and turns off when the brake pedal is released. 2 Input signal check See input signal check on page 05–745.  check the indicator light when the brake pedal ...

Circuit description
The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0110/43 is recorded when a short is detected in the side squib (rh) circuit. Wiring diagram ...