Toyota Corolla (E210): Steering wheel

Adjustment procedure

1. Hold the steering wheel and push the lever down.

2. Adjust to the ideal position by

2. Adjust to the ideal position by moving the steering wheel horizontally and vertically.

After adjustment, pull the lever up to secure the steering wheel.

WARNING

WARNING

■Caution while driving

Do not adjust the steering wheel while driving.

Doing so may cause the driver to mishandle the vehicle and cause an accident, resulting in death or serious injury.

■After adjusting the steering wheel

Make sure that the steering wheel is securely locked.

Otherwise, the steering wheel may move suddenly, possibly causing an accident, and resulting in death or serious injury. Also, the horn may not sound if the steering wheel is not securely locked.

Horn

To sound the horn, press on or close to themark.

Inside rear view mirror

    Share this page:

    Other materials:

    Adjustment
    Hint: in the rh side, work in the same procedure as in the lh side. Since the centering bolt is used as a door side hinge bolt, the door hinge cannot be adjusted with it on. Substitute the bolt with washer for the centering bolt. 1. Inspect rear door panel sub–assy lh Check ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    Terminals of ecu
    1. Inspect integration relay Disconnect the connector and check the continuity of each terminal of the disconnected connector. Standard : If the result is not as specified, the vehicle’s side may malfunction. Reconnect the connector and check each terminal. Standard: If ...