Toyota Corolla (E170) 2014–2019 Owners Manual
Toyota Corolla (E170) 2014–2019 Owners Manual
- For your information
- For safety and security
- Instrument cluster
- Warning lights and indicators
- Gauges and meters (drive monitor display)
- Gauges and meters (multi-information display)
- Eco Driving Indicator (except vehicles with a manual transmission)
- Operation of each component
- Key information
- Opening, closing and locking the doors
- Adjusting the seats
- Opening and closing the windows
- Driving
- Before driving
- Driving procedures
- Operating the lights and wipers
- Refueling
- Using the driving support systems
- Driving tips
- Interior features
- Basic Operations
- Using the audio system
- Using the radio
- Playing audio CDs and MP3/WMA discs
- Using an external device
- Using Bluetooth® devices
- “SET UP” menu
- Bluetooth® Audio
- Bluetooth® Phone
- Bluetooth®
- Basic Operations (Multimedia system)
- Setup (Multimedia system)
- Using the Multimedia system
- Using the radio (Multimedia system)
- Playing an audio CD and MP3/WMA/AAC discs (Multimedia system)
- Using an external device (Multimedia system)
- Connecting Bluetooth® (Multimedia system)
- Bluetooth® Audio (Multimedia system)
- Bluetooth® phone (Multimedia system)
- Bluetooth® (Multimedia system)
- Using the voice command system (Multimedia system)
- Interior features
- Using the air conditioning system and defogger
- Using the interior lights
- Using the storage features
- Other interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- What to do if... (Troubleshooting)
Other materials:
Dtc check/clear
Notice:
if there is no dtc in the normal mode, check the pending
fault code using the continuous test results
function (mode 7 for sae j1979) on the obd ii scan
tool or the hand–held tester.
Hand–held tester only:
when the diagnosis system is switched from the normal
mode to the ...
Diagnostic trouble code chart
Notice:
when removing the part, turn the ignition switch to off.
Hint:
using sst 09843–18040, it connect the terminal tc and cg of dlc3.
If any abnormality is not found when inspecting parts, inspect the ecu and
ground points for poor contact.
If a malfunction code is displayed during ...
Inspection procedure
1 Check connector
Disconnect the negative (–) terminal cable from the battery, and wait at
least for 90 seconds.
check the connection of the combination meter connector and the
airbag sensor assy center connectors.
Ok:
the connectors are connected.
2 Check combination ...