Toyota Corolla (E170): Before driving

Share this page:

Other materials:

Side mudguard sub–assy lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...

Circuit description
Refer to dtc p0115 Dtc no. Dtc detection condition Trouble area P0116 If engine coolant temperature (ect) was between 35 c (95 °F) and 60 c (140 °F) when starting the engine, and also conditions (a) and (b) are met:  vehicle has run with acceleration an ...

Inspection procedure
1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...