Toyota Corolla (E170): How to check and change detailed Bluetooth® settings

1 Display the “Bluetooth* Setup” screen. 2 Select “System Settings”.

3 The following screen is displayed:

1 Bluetooth® Power on/off You can change Bluetooth® function on/off 2 Bluetooth® Name
3 Change PIN-code
4 Bluetooth® Address
5 Display Phone Status
You can set the system to show the status confirmation display when connecting a telephone
6 Display Audio Player Status You can set the system to show the status confirmation display when connecting an audio player
7 Compatibility profile of the system 8 Restore default settings

*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.

Editing the Bluetooth* PIN

    Share this page:

    Other materials:

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove parking brake hole cover sub–assy 4. Remove floor shift shift lever knob sub–assy (m/t transaxle) 5. Remove shifting hole cover sub–assy (m/t transaxle) 6. Remove console panel upper 7. Remove conso ...

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...