Ecm (1zz–fe)
Replacement
1. Disconnect battery negative terminal
2. Remove glove compartment door assy
3. Remove ecm
Remove the 2 clips using a clip remover. Then, open the
cover.
Disconnect the 4 ecm connectors.
remove the wire harness from the wire harness clamp.
Remove the 2 ...
Pressing power switch does not start system
Wiring diagram
Inspection procedure
1 Inspect radio receiver assy(+b, acc, gnd)
Check that the continuity between terminals at each
condition, as shown in the chart.
Standard:
Check that the voltage between terminals at each condition,
as shown in the chart.
Standard:
...
Inspection
1. Intake air flow meter sub–assy
Inspect the intake air flow meter resistance.
Using an ohmmeter, measure the resistance between
terminals tha and e2.
Resistance:
at –20 c (–4 f) 13.6 To 18.4 KΩ
at 20 c (68 f) 2.21 To 2.69 KΩ
at 60 c (140 f) 0.49 To 0.67 KΩ ...