Toyota Corolla (E210) 2019-2026 Owners Manual / For safety and security / Child safety / Using a top tether anchorage (for Puerto Rico)

Toyota Corolla (E210): Using a top tether anchorage (for Puerto Rico)

■ Top tether anchorages

Top tether anchorages are provided for each rear seat.

Use top tether anchorages when fixing the top strap.

  1. Top tether anchorages
  2. Top strap

■ Fixing the top strap to the top tether anchorages

Install the child restraint system in accordance to the operation manual enclosed with the child restraint system.

Rear outboard seats

pen the top tether anchorage cover, latch the hook onto the top tether anchorage and tighten the top strap.

Make sure the top strap is securely latched.

  1. Hook
  2. Top strap

Rear center seat

Latch the hook onto the top tether anchorage and tighten the top strap.

Make sure the top strap is securely latched.

  1. Hook
  2. Top strap

WARNING

■When installing a child restraint system

Observe the following precautions.

Failure to do so may result in death or serious injury.

  • Firmly attach the top strap and make sure that the belt is not twisted.
  • Do not attach the top strap to anything other than the top tether anchorages.
  • After securing a child restraint system, never adjust the seat.
  • Follow all installation instructions provided by the child restraint system manufacturer.

NOTICE

■Top tether anchorages

When not in use, make certain to close the lid. If it remains open, the lid may be damaged.

    Share this page:

    Other materials:

    Malfunction in fuel receiver gauge
    Wiring diagram Inspection procedere 1 Inspect fuel sender gage assy Disconnect the connector fuel sender gauge. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously. S ...

    Malfunction in water temperature receiver gauge
    Wiring diagram Inspection procedure 1 Read value of hand–held tester Check output value of ecm.  Connect the hand–held tester to dlc3.  Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–he ...

    Glossary of sae and toyota terms
    This glossary lists all sae–j1930 terms and abbreviations used in this manual in compliance with sae recommendations, as well as their toyota equivalents. ...