Toyota Corolla (E210): For safety and security

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Thermostat
Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...

Speed control main switch assy
Replacement 1. Disconnect battery negative terminal 2. Inspect place front wheels facing straight ahead 3. Remove horn button assy 4. Remove steering wheel assy sst 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021) 5. Remove speed control main switch assy Remov ...