Toyota Corolla (E210): Interior

  1. SRS airbags
  2. Floor mats
  3. Front seats
  4. Head restraints
  5. Seat belts
  6. Console box
  7. Inside lock buttons
  8. Cup holders
  9. Rear seats
  10. Rear seat heater switches*

*: If equipped

■Ceiling

  1. Inside rear view mirror
  2. Sun visors
  3. Vanity mirrors
  4. Vanity lights*
  5. Interior lights/personal lights
  6. Moon roof switches*
  7. "SOS" button*
  8. Assist grips

*: If equipped

    Share this page:

    Other materials:

    Inspection procedure
    1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    General information
    There are many ecu controlled systems used in the corolla. In general, ecu controlled system are considered to be very intricate and require a high level of technical knowledge and expert skill to troubleshoot. The fact is, however, that if you proceed by inspecting the circuits one by one, ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...