Toyota Corolla (E120): Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Remove instrument panel sub–assy lower

  1. Remove the screw from the glove compartment door stopper sub–assy.
  2.  pull the instrument panel sub–assy lower to remove it.

4. Separate passenger airbag connector

  1. Separate the instrument panel passenger airbag assy connector.

5. Remove instrument panel passenger air bag assy

  1. Remove the bolt.
  2.  remove the 2 nuts and instrument panel passenger airbag assy.

6. Install instrument panel passenger air bag assy

Torque:
bolt: 20 nvm (204 kgfvcm, 15 ftvlbf)

7. Inspect instrument panel passenger air bag assy

8. Inspect srs warning light

    Share this page:

    Other materials:

    Circuit description
    The side airbag sensor assy (rh) circuit consists of the diagnosis circuit and lateral deceleration sensor, etc. It receives signals from the lateral deceleration sensor, judges whether or not the srs must be activated, and detects diagnosis system malfunction. Dtc b1140/32 is recorded wh ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Stopping
    ► Automatic transmission or continuously variable transmission 1 With the shift lever in D, depress the brake pedal. 2 If necessary, set the parking brake. If the vehicle is to be stopped for an extended period of time, shift the shift lever to P or N. (, 174, 176) ►  Manual ...