Toyota Corolla (E120) 2002–2008 Repair Manual / Supplemental restraint system

Toyota Corolla (E120): Supplemental restraint system

Share this page:

Other materials:

Circuit description
In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...

Check open circuit
For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...

Monitor description
While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...