Toyota Corolla (E120): Air bag sensor front lh

Components

Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Remove air bag sensor front lh

  1. Disconnect the connector from the airbag sensor front lh.
  2.  remove the 2 bolts and airbag sensor front lh.

4. Inspect air bag sensor front lh

5. Install air bag sensor front lh

  1.  check that the ignition switch is turned to off.
  2.  check that the battery negative terminal is disconnected.

    Notice

    : do not start the operation for 90 seconds after removing the terminal.

  3.  install the airbag sensor front lh with the 2 bolts.

    Torque: 8.0 Nvm (82 kgfvcm, 71 invlbf)

  4.  connect the connector to the airbag sensor front lh.
  5.  check that no play is identified.

6. Inspect srs warning light

    Share this page:

    Other materials:

    BSM (Blind Spot Monitor)
    The Blind Spot Monitor is a system that uses rear side radar sensors installed on the inner side of the rear bumper on the left and right side to assist the driver in confirming safety when changing lanes. WARNING ■Cautions regarding the use of the system The driver is solely responsible for sa ...

    Circuit description
    The variable valve timing (vvt) system includes the ecm, the oil control valve (ocv) and the vvt controller. The ecm sends a target ”duty–cycle” control signal to the ocv. This control signal, applied to the ocv, regulates the oil pressure supplied to the vvt controller. Camshaft timin ...

    Inspection procedure
    1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...