Toyota Corolla (E210): For safe use

Share this page:

Other materials:

Check and replace ecu
Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...

Inspection procedure
1 Check voltage at ig2 of airbag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector of the airbag sensor assy center.  connect the negative (–) terminal cable to the battery, and wa ...

Sliding roof/convertible
Service data Torque specification Engine hood/door Torque specification Exterior/interior trim Torque specification Cruise control Service data Torque specification ...