Toyota Corolla (E210): Emergency assistance

Share this page:

Other materials:

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Terminals of ecu
1. Inspect tvip ecu Inspect the ecu–b, dome and ecu–ig fuses. disconnect the tvip ecu connector, and the continuity and voltage of check each terminal of the disconnected connector. Standard: If the result is not as specified, the vehicle’s side may malfunction. Reco ...

Engine (ignition) switch (vehicles with a smart key system)
Performing the following operations when carrying the electronic key on your person starts the engine or changes engine switch modes. Starting the engine 1. Check that the parking brake is set. 2. Check that the shift lever is in P. 3. Firmly depress the brake pedal. and a message will be display ...