Toyota Corolla (E170): Automatic air conditioning system

Air outlets and fan speed are automatically adjusted according to the temperature setting.

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Removal and installation of engine intake parts
If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.  when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.  when inst ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...