Toyota Corolla (E170): Using automatic mode

1 Press The dehumidification function begins to operate. Air outlets and fan speed are.

The dehumidification function begins to operate. Air outlets and fan speed are automatically adjusted according to the temperature setting.

2 Adjust the temperature setting.

3 To stop the operation, press ■ If the system is operated manually in automatic mode again.

■ If the system is operated manually in automatic mode

If the fan speed setting or air flow modes are operated, the automatic mode indicator goes off. However, automatic mode for functions other than that operated are maintained.

    Share this page:

    Other materials:

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Air outlet layout and operations
    ■ Location of air outlets The air outlets and air volume changes according to the selected air flow mode. :If equipped ■ Adjusting the position of and opening and closing the air outlets Front center Direct air flow to the left or right, up or down Front right-hand side Direct air flow to th ...

    Changing gears in the M position
    To enter 10-speed sport sequential shiftmatic mode, shift the shift lever to M position. Gear steps can then be selected by operating the shift lever or paddle shift switches, allowing you to drive in the gear step of your choosing. Upshifting Downshifting The gear changes once every time the ...