Toyota Corolla (E170) 2014–2019 Owners Manual / Instrument cluster / Gauges and meters (multi-information display)

Toyota Corolla (E170): Gauges and meters (multi-information display)

The displayed content may differ depending on the type of meter.

1 Tachometer

1 Tachometer
Displays the engine speed in revolutions per minute.

2 Speedometer
3 Fuel gauge
4 Multi-information display The multi-information display presents the driver with a variety of drivingrelated data including the current outside air temperature.

5 Display change button
Switches the trip information.

6 Engine coolant temperature gauge Displays the engine coolant temperature.

Share this page:

Other materials:

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

For vehicles equipped with mobile communication system
Install an antenna as far as possible away from the ecu and sensors of the vehicle’s electronic systems.  install an antenna feeder at least 20 cm (7.87 In.) Away from the ecu and sensors of the vehicle’s electronic systems. For details of the ecu and sensors locations, refer ...

Catalyst monitor (o2s type)
Preconditions The monitor will not run unless: mil is off. Engine coolant temperature (ect) is 176°f (80 °C) or greater. Intake air temperature (iat) is 14°f (–10 °C) or greater.* Notice: * 2002 and later my vehicles: the readiness test can be completed in cold ambient c ...