Toyota Corolla (E120): Circuit description

The vehicle speed sensor circuit is sent to cruise control ecu assy as a vehicle speed signal. For each rotation of the shaft, the vehicle speed sensor sends a signal through the combination meter assembly to the cruise control ecu assy (see the following chart). The cruise control ecu assy calculates the vehicle speed from this pulse frequency.

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Overhaul
    Hint: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove t ...

    Circuit description
    The throttle position sensor is mounted in the throttle body and detects the throttle valve opening angle. When the throttle valve is fully closed, a voltage of approximately 0.3 To 1.0 V is applied to terminal vta of the ecm. The voltage applied to terminal vta of the ecm increases in pro ...

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...