Toyota Corolla (E170) 2014–2019 Owners Manual / Driving / Driving procedures
Toyota Corolla (E170): Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Engine (ignition) switch (vehicles with a smart key system)
- Automatic transmission
- Continuously variable transmission (vehicles without paddle shift switches)
- Continuously variable transmission (vehicles with paddle shift switches)
- Manual transmission
- Turn signal lever
- Parking brake
Other materials:
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the horn button assy
and the airbag sensor assy center.
for the oran ...
Inspection procedure
Hint:
hand–held tester only:
narrowing down the trouble area is possible by performing ”a/f control” active
test (heated oxygen
sensor or other trouble areas can be distinguished).
Perform active test using hand–held tester (a/f control).
Hint:
”a/f control” is the active te ...
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove front wheel rh
3. Remove front fender liner rh
4. Remove brake actuator with bracket
turn the latch of the actuator connector to disconnect the
connector. ...


