Toyota Corolla (E170): Engine (ignition) switch (vehicles without a smart key system)

Driving procedures

Starting the engine

Other materials:

Under hood
General maintenance 1. General notes maintenance requirements vary depending on the country. Check the maintenance schedule in the owner’s manual supplement. Following the maintenance schedule is mandatory. Determine the appropriate time to service the vehicle using either miles driv ...

Circuit description
The vapor pressure sensor and the vsv for the canister closed valve (ccv) are used to detect abnormalities in the evaporative emission control system. The ecm decides whether there is an abnormality in the evaporative emission control system based on the vapor pressure sensor signal. Dtc p0 ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...