Toyota Corolla (E170): Starting the engine

► Automatic transmission or continuously variable transmission

1 Check that the parking brake is set.

2 Check that the shift lever is set in P.

3 Firmly depress the brake pedal.

4 Turn the engine switch to the “START” position and start the engine.

► Manual transmission

1 Check that the parking brake is set.

2 Check that the shift lever is set in N.

3 Firmly depress the clutch pedal.

4 Turn the engine switch to the “START” position and start the engine.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    On–vehicle inspection
    1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

    Terminals of ecu
    Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...