Toyota Corolla (E170) 2014–2019 Owners Manual / Driving / Driving procedures / Continuously variable transmission (vehicles without paddle shift switches)

Toyota Corolla (E170): Continuously variable transmission (vehicles without paddle shift switches)

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

Inspection procedure
1 Inspect transmission wire(sl) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission wire c ...

Shifting the shift lever to R
Shift the shift lever to R while lifting up the ring section. ■Maximum allowable speeds Observe the following maximum allowable speeds in each gear when maximum acceleration is necessary. mph (km/h) NOTICE ■To prevent damage to the transmission ●Do not lift up the ring ...