Toyota Corolla (E170): Turn signal lever
Operating instructions
1 Right turn
2 Lane change to the right (move the lever partway and release it)
The right hand signals will flash 3 times.
3 Lane change to the left (move the lever partway and release it) The left hand signals will flash 3 times.
4 Left turn
■Turn signals can be operated when
►Vehicles without a smart key system The engine switch is in the “ON” position.
►Vehicles with a smart key system The engine switch is in IGNITION ON mode.
■If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
■Customization
The number of times the turn signals flash during a lane change can be changed. (Customizable feature )
Other materials:
Replacement
1. Remove front door scuff plate rh
Using a screwdriver, remove the front door scuff plate rh.
Hint:
tape the screwdriver tip before use.
Remove front door scuff plate lh
Remove rear door scuff plate rh
Using a screwdriver, remove the rear door scuff plate rh.
Hint:
tap ...
Alarm
The alarm uses light and
sound to give an alert when
an intrusion is detected.
The alarm is triggered in the
following situations when
the alarm is set:
A locked door or trunk is
unlocked or opened in any
way other than using the
entry function (if equipped),
wireless remote control,
mechani ...
Inspection procedure
1 Check ignition or starter switch assy
Check the ignition switch, as shown in the illustration and
table.
Standard:
2 Check fuse (ecu–b)
Remove the fuse from the instrument panel j/b.
check the continuity of the fuse.
Standard: continuity
3 Check relay (m ...