Toyota Corolla (E170): Using an external device

Share this page:

Other materials:

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

For vehicles equipped with mobile communication system
Install an antenna as far as possible away from the ecu and sensors of the vehicle’s electronic systems.  install an antenna feeder at least 20 cm (7.87 In.) Away from the ecu and sensors of the vehicle’s electronic systems. For details of the ecu and sensors locations, refer ...

Replacement
1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove front wheel rh 3. Remove front fender liner rh 4. Remove brake actuator with bracket  turn the latch of the actuator connector to disconnect the connector. ...