Toyota Corolla (E170): Using the AUX port

This port can be used to connect a portable audio device and listen to it through the vehicle’s speakers. Press “AUX” is displayed.until “AUX” is displayed.

Connecting a portable player

■Operating portable audio devices connected to the audio system

The volume can be adjusted using the vehicle's audio controls. All other adjustments must be made on the portable audio device itself.

■When using a portable audio device connected to the power outlet

Noise may occur during playback. Use the power source of the portable audio device.

    Share this page:

    Other materials:

    Circuit description
    The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0100/13 is recorded when a short is detected in the d squib circuit. Wiring diagram ...

    Positioning a floor jack
    When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. ◆ Front ◆ Rear 1 Take out ...

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the instrument panel ...