Toyota Corolla (E170): Initialization
Select “Initialize” using 
.
● Initializing the sound settings
Select “Sound setting” using and press
(YES).
For details about sound settings: ● Initializing the device information
Select “Car Device Info” using and
press 
(YES).
Automatic connection of a portable device, the automatic connection confirmation display and passkey will be initialized.
● Initializing all the settings
Select “All Initialize” using and
press 
(YES).
Other materials:
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove front wheel rh
3. Remove front fender liner rh
4. Remove brake actuator with bracket
turn the latch of the actuator connector to disconnect the
connector. ...
On–vehicle inspection
1. Connect hand–held tester:
connect the hand–held tester to the dlc3.
start the engine and run it at idle.
select the active test mode on the hand–held tester.
Hint:
please refer to the hand–held tester operator’s manual for further details.
2. Inspect actua ...
For vehicles equipped with catalytic converter
Caution:
if large amount of unburned fuel flows into the converter, it may cause
overheating and a fire hazard.
To prevent this, observe the following precautions.
Use only unleaded gasoline.
avoid prolonged idling.
Avoid running the engine at idle speed for more than 20 minutes. ...