Toyota Corolla (E210): Inside rear view mirror

The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view.

Adjusting the height of rear view mirror

The height of the rear view mirror can be adjusted to suit your driving posture.

Adjust the height of the rear view mirror by moving it up and down.

WARNING

WARNING

■Caution while driving

Do not adjust the position of the mirror while driving.

Doing so may lead to mishandling of the vehicle and cause an accident, resulting in death or serious injury.

Anti-glare function

Reflected light from the headlights of vehicles behind can be reduced by operating the lever.

  1. Normal position
  2. Anti-glare position
    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...

    Problem symptoms table
    Hint: proceed with troubleshooting of each circuit in the table below. Symptom Suspect area When the ignition switch is in the on position, the srs warning light sometimes comes on after approximately 6 seconds.  Srs warning light ci ...

    Positioning a floor jack
    When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. Location of the jack point ■ Front ■ Rea ...