Toyota Corolla (E210) 2019-2026 Owners Manual / Before driving / Opening, closing and locking the doors

Toyota Corolla (E210): Opening, closing and locking the doors

Share this page:

Other materials:

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

Inspection procedure
1 Check operation(starter) Check that the starter operates normally and that the engine starts. 2 Input signal check See input signal check on page 05–745.  check the indicator light when shifting into except d position. Ok: the indicator light goes off when shifting ...

Inspection procedure
1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...