Toyota Corolla (E210): Air outlet layout and operations

■ Location of air outlets

The air outlets and air volume changes according to the selected air flow mode.

:If equipped

■ Adjusting the position of :If equipped

■ Adjusting the position of and opening and closing the air outlets

Front center

Direct air flow to the left or right, up

Direct air flow to the left or right, up or down

Front right-hand side

Direct air flow to the left or right, up

Direct air flow to the left or right, up or down

Front left-hand side

Direct air flow to the left or right, up

Direct air flow to the left or right, up or down

WARNING

■To prevent the windshield defogger from operating improperly

Do not place anything on the instrument panel which may cover the air outlets. Otherwise, air flow may be obstructed, preventing the windshield defoggers from defogging.

Heated steering wheel/seat heaters

    Share this page:

    Other materials:

    Ecu power source circuit
    Circuit description This circuit provides power to operate the tvip ecu. Wiring diagram Inspection procedure 1 Check fuse (ecu–b) Remove the fuse from the instrument panel j/b.  check the continuity of the fuse. Standard: continuity 2 Check tvip ecu Disconnect ...

    Auto connection
    To turn auto connection mode on, set “Bluetooth* Power” to on. When you register a phone, auto connection will be activated. Always set it to this mode and leave the Bluetooth® phone in a place where a connection can be established. When the engine switch is turned to ACCESSORY or ON <IG ...

    Inspection procedure
    1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...