Toyota Corolla (E120): Inspection procedure
1 Inspect park/neutral position switch assy
- Disconnect the park/neutral position switch connector.
- measure resistance according to the value(s) in the table below when the shift lever is moved to each position.
Standard:
2 Check harness and connector(park/neutral position switch – ecm)
- Connect the the park/neutral position switch connector.
- turn the ignition switch to the on position, and measure the voltage according to the value(s) in the table below when the shift lever is moved to each position.
Standard:
Hint
: *: the voltage will drop slightly due to lighting up of the back up light.
Replace ecm
Other materials:
Towing with a wheel-lift type truck
► From the front
Release the parking brake.
► From the rear
Use a towing dolly under the front wheels.
Vehicles without a smart key system: When not using a towing dolly, turn the
engine switch to the “ACC” position and shift the shift lever to N.
Vehicles with a smart key ...
Windshield wiper switch assy
Replacement
1. Remove steering column cover lwr
Remove 3 screws and steering column cover lwr.
2. Remove windshield wiper switch assy
Disconnect the connecter of the windshield wiper switch.
release the claw and pull out the windshield wiper switch
assy as shown in the ...
Inspection procedure
1 Check fuse(ecu–ig)
Remove the ecu–ig fuse from the instrument panel j/b.
check the continuity of the ecu–ig fuse.
Ok: continuity
2 Inspect terminal voltage(b)
Remove the cruise control ecu assy with connector still
connected.
turn the ignition switch ...