Toyota Corolla (E120): Circuit description

The park/neutral position switch detects the shift lever position and sends signals to the ecm.

Monitor description

Monitor description

The park/neutral position switch detects the gearshift position and sends a signal to the ecm.

For security, the park/neutral position switch detects the gearshift position so that engine can be started only when the vehicle is in p or n shift position.

When the park/neutral position switch sends more than one signal at a time from switch positions p, r, n, 2, or l the ecm interprets this as a fault in the switch. The ecm will turn on the mil.

Monitor strategy

P0705

P0850

P0850

Typical enabling condition

Typical enabling condition

P0705

P0805

P0805

Typical malfunction thresholds

Typical malfunction thresholds

P0705

P0850

P0850

Component operating range

Component operating range

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...

    Heated steering wheel/seat heaters
    Heated steering wheel Warms up the grip of the steering wheel Seat heaters Warm up the seat upholstery WARNING To prevent minor burn injuries Care should be taken if anyone in the following categories comes in contact with the steering wheel or seats when the heater is on: Babies, small chil ...

    Tire & wheel
    Wheel and tire system Inspection 1. Inspect tire  check the tires for wear and proper inflation pressure. Cold tire inflation pressure: Using a dial indicator, check the tire runout. Tire runout: 3.0 Mm (0.118 In.) Or less 2. Rotate tire Hint: see the illustration ...