Toyota Corolla (E120): Adjustment
1. Remove rear wheel
2. Adjust rear drum brake shoe clearance
3. Install rear wheel
torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
4. Inspect parking brake lever travel
- pull the parking brake lever to the fully applied position, and
count the number of clicks.
Parking brake lever travel: 6 – 9 clicks at 196 n (20 kgf, 44.1 Lbf)
5. Adjust parking brake lever travel
- remove the rear console box sub–assy .
- Loosen the lock nut and turn the adjusting nut until the lever travel turns correct.
- tighten the lock nut.
Torque: 5.0 Nvm (55 Kgf·cm, 44 in.Vlbf)
- install the rear console box sub–assy.
Other materials:
Adjustment
1. Put vehicle these conditions
tire inflation pressure is the specified value .
start the engine.
2. Adjust fog light aim
The fog light aim can be adjusting by moving the aiming
screw in the vertical direction.
Hint:
the optical aim moves upward when turning a scr ...
Circuit description
The side airbag sensor assy (rh) circuit consists of the diagnosis circuit
and lateral deceleration sensor, etc.
It receives signals from the lateral deceleration sensor, judges whether or not
the srs must be activated,
and detects diagnosis system malfunction.
Dtc b1140/32 is recorded wh ...
Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center)
Turn the ignition switch to the lock position.
disconnect the aribag sensor assy center connector.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Check wire harness(cg of dl ...