Toyota Corolla (E210): Favorite settings

My Settings

Drivers are identified using devices such as electronic keys to store the vehicle settings for each. Then the information can be recalled the next time the vehicle is driven.

Authentication devices can be assigned in advance to drivers so that they can drive using their preferred settings.

Settings for 3 drivers can be stored in My Settings.

For information on authentication devices registration/ deletion, changing the driver's name, initializing driver registered settings, manually switching drivers and deleting drivers registration refer to the "MULTIMEDIA OWNER'S MANUAL".

Types of assigned authentication devices

An individual can be identified using the following authentication devices.

  • Electronic key (vehicles with smart system)

An individual is identified when the smart key system detects their electronic key.

  • Bluetooth device

An individual is identified when a Bluetooth device is connected to the audio system. For information on how to connect Bluetooth devices, refer to the "MULTIMEDIA OWNER'S MANUAL". When an individual is identified with an electronic key identifying using a Bluetooth device is not performed.

Recalled functions

When an individual is identified from an authentication device, settings for the following functions are recalled.

  • Meter displays and audio system information*

When an individual is identified, the display settings used when the engine switch was last turned off are recalled.

  • Vehicle settings that can be set using the audio system*

When an individual is identified, the vehicle settings used when the engine switch was last turned off are recalled.

*: Some settings are excluded

    Share this page:

    Other materials:

    Folding the mirrors
    Push the mirror back in the direction of the vehicle’s rear. ■Mirror angle can be adjusted when ► Vehicles without a smart key system The engine switch is in the “ACC” or “ON” position. ►Vehicles with a smart key system The engine switch is in ACCESSORY or IGNITION ...

    Handling of hose clamps
    Before removing the hose, check the depth of the inserting portion and the clamp position in order to restore it surely.  change a deformed or dented clamp for a new one.  in case of reusing the hose, install the clamp on the hose where it has a clamp track.  for a ...

    Overhaul
    Notice: when installing, coat the parts indicated by the arrow with power steering fluid or molybdenum disulfide lithium base grease. 1. Precaution 2. Disconnect battery negative terminal 3. Inspect center front wheel 4. Remove horn button assy 5. Remove steering wheel assy sst 09950–50013 ...