Toyota Corolla (E120): Initialization
1. Reset memory
Caution
: perform the reset memory (at initialization) when replacing the automatic transaxle assy, engine assy or ecm.
Notice
: hand–held tester only
- Turn the ignition switch off.
- connect the hand–held tester to the dlc3.
- turn the ignition switch to the on position.
- perform the reset memory procedure from the engine menu.
Caution
: after performing the reset memory, be sure to perform the road test described earlier.
Other materials:
Circuit description
The srs warning light is located on the combination meter.
When the srs is normal, the srs warning light lights up for approx. 6 Seconds
after the ignition switch is
turned from the lock position to on position, and then turns off automatically.
If there is a malfunction in the srs, the srs ...
Operating instructions
Turning the end of the lever turns on the lights as follows:
► Type A
1 The daytime running lights turn
on.
2 The side marker, parking, tail,
license plate, daytime running lights and instrument panel lights turn on.
3 The headlights and all the lights
listed above (except daytime ...
Transmission valve body assy (atm)
Replacement
1. Remove engine under cover lh
2. Drain automatic transaxle fluid
remove the drain plug, gasket and drain atf.
install a new gasket and drain plug.
Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf)
3. Remove automatic transaxle oil pan sub–assy
Remove the 18 ...