Toyota Corolla (E210) 2019-2025 Owners Manual / When trouble arises / Essential information / If the vehicle is submerged or
water on the road is rising
Toyota Corolla (E210): If the vehicle is submerged or water on the road is rising
This vehicle is not designed to be able to drive on roads that are deeply flooded with water. Do not drive on roads where the roads may be submerged or the water may be rising. It is dangerous to remain in the vehicle, if it is anticipated that the vehicle will be flooded or set adrift. Remain calm and follow the following.
- If the door can be opened, open the door and exit the vehicle.
- If the door cannot be opened, open the window using the power window switch and ensure an escape route.
- If the window can be opened, exit the vehicle through the window.
- If the door and window cannot be opened due to the rising water, remain calm, wait until the water level inside the vehicle rises to the point that the water pressure inside of the vehicle equals the water pressure outside of the vehicle and then open the door after waiting for the rising water to enter the vehicle, and exit the vehicle.
When the outside water level exceeds half the height of the door, the door cannot be opened from the inside due to water pressure.
■Water level exceeds the floor
When the water level exceeds the floor and time has passed, the electrical equipment will get damaged, the power windows will not operate, the engine stop, and the vehicle may not be able to get moving.
■Using an emergency escape hammer*
Laminated glass is used in the windshield on this vehicle.
Laminated glass cannot be shattered with an emergency hammer*.
Tempered glass is used in the windows on this vehicle.
*: Contact your Toyota dealer or aftermarket accessory manufacturer for further information about an emergency hammer.
WARNING
■Caution while driving
Do not drive on roads where the roads may be submerged or the water may be rising. Otherwise the vehicle may be damaged and cannot move, as well as become flooded and set adrift, which may lead to death.
Other materials:
Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center)
Turn the ignition switch to the lock position.
disconnect the aribag sensor assy center connector.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Check wire harness(cg of dl ...
Replacement
1. Remove combination meter assembly
2. Disconnect brake master cylinder push rod clevis
remove the clip and push rod clevis pin and wave washer, and
disconnect the push rod clevis from
the brake pedal.
3. Remove brake pedal support sub–assy
Remove the bolt from the bra ...
Symptom simulation
Hint:
the most difficult case in troubleshooting is when no symptoms occurs. In such
cases, a thorough customer
problem analysis must be carried out. Then the same or similar conditions and
environment in which the
problem occurred in the customer’s vehicle should be simulated. No matter ho ...


