Toyota Corolla (E210) 2019-2026 Owners Manual / When trouble arises / Steps to take in an emergency
Toyota Corolla (E210): Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire
- If the engine will not start
- If the electronic key does not operate properly (vehicles with a smart key system)
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
Other materials:
Starting system
Inspection
1. Inspect starter assy
Notice:
these tests must be performed within 3 to 5 seconds to
prevent burnout of the coil.
perform the pull–in test.
Remove the nut, then disconnect the lead wire from
terminal c.
Connect the battery to the starter repai ...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...
Have the malfunction repaired immediately. (vehicles with a smart key system)
After taking the specified steps to correct the suspected problem, check that
the warning message and light go off.
■Warning buzzer ...