Toyota Corolla (E210): If the vehicle becomes stuck

Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt or snow:

Recovering procedure

1. Stop the engine. Set the parking brake and shift the shift lever to P.

Do not press the shift release button after shifting the shift lever to P.

2. Remove the mud, snow or sand from around the front wheels.

3. Place wood, stones or some other material under the front wheels to help provide traction.

4. Restart the engine.

5. Shift the shift lever to D or R and release the parking brake. Then, while exercising caution, depress the accelerator pedal.

■When it is difficult to free the vehicle

Press the TRAC.switch to turn off TRAC.

Type A

Type B

Type B

WARNING

WARNING

■When attempting to free a stuck vehicle

If you choose to push the vehicle back and forth to free it, make sure the surrounding area is clear to avoid striking other vehicles, objects or people. The vehicle may also lunge forward or lunge back suddenly as it becomes free.

Use extreme caution.

■When shifting the shift lever

Be careful not to shift the shift lever with the accelerator pedal depressed.

This may lead to unexpected rapid acceleration of the vehicle that may cause an accident resulting in death or serious injury.

NOTICE

■To avoid damaging the transmission and other components

  • Avoid spinning the front wheels and depressing the accelerator pedal more than necessary.
  • If the vehicle remains stuck even after these procedures are performed, the vehicle may require towing to be freed.
    Share this page:

    Other materials:

    Displaying the device status
    Select “Bluetooth* info” using . ● Displaying the device name Select “Device Name” using . ● Displaying the device address Select “Device Address” using . *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. ...

    Terminals of ecu
    1. Inspect tvip ecu Inspect the ecu–b, dome and ecu–ig fuses. disconnect the tvip ecu connector, and the continuity and voltage of check each terminal of the disconnected connector. Standard: If the result is not as specified, the vehicle’s side may malfunction. Reco ...

    Front differential oil seal (atm)
    Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 5. Remove fron ...