Toyota Corolla (E210): Vehicle specifications

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Overhaul
1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove air cleaner cap sub–assy 3. Remove brake master cylinder sub–assy  disconnect the brake fluid level switch connector from master cylinder reservoir subâ ...

Heater & air conditioner
Preparation Sst Recomended tools Equipment Lubricant ...