Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / List of disable a moniter
Toyota Corolla (E120): List of disable a moniter
Hint
: this table indicates ecm monitoring status for the items in the upper columns if the dtcs in each line on the left are being set.
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...
Circuit description
When the idle switch is turned on, a signal is sent to the cruise control ecu
assy. The cruise control ecu
assy uses this signal to correct the discrepancy between the throttle valve
position and the actuator position
sensor values to enable accurate cruise control at the set speed. If the idl ...
Disabling the TRAC system
If the vehicle gets stuck in mud, dirt or snow, the TRAC system may reduce power
from the engine to the wheels. Pressing
to turn the system off may make it
easier for you to rock the vehicle in order to free it.
To turn the TRAC system off, quickly press and release
.
The “TRAC OFF” ind ...