Toyota Corolla (E210): Engine compartment

Share this page:

Other materials:

Overhaul
1. Remove speedometer drive (mtm) gear Remove the speedometer drive (mtm) gear from the front differential case. 2. Remove front differential ring gear Place matchmarks on the front differential ring gear and front differential case. Remove the 8 bolts. Using a hamme ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

On–vehicle inspection
1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...