Toyota Corolla (E210): Maintenance and care

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

    Manual transaxle oil
    On–vehicle inspection 1. Inspect transaxle oil Stop the vehicle on the level place.  remove the transmission filler plug and gasket.  check that the oil surface is within 5 mm (0.20 In.) From the lowest position of the inner surface of the transmission filler plug openin ...

    Inspection procedure
    1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...