Toyota Corolla (E210) 2019-2026 Owners Manual / Maintenance and care / Positioning a floor jack
Toyota Corolla (E210): Positioning a floor jack
When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely.
When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury.
Location of the jack point
■ Front
■ Rear
Type A
Type B
Other materials:
Inspection procedure
1 Inspect ecm(+b voltage)
Turn the ignition switch on.
measure the voltage between the terminals of the e4 and
e6 ecm connectors.
Standard:
2 Check harness and connector(ecm – body ground)
Disconnect the e4 ecm connector.
check the resistance between the wire ...
On–vehicle inspection
1. Inspect w/receiver condenser assy
if a fin of the w/receiver condenser assy is dirty, clean it with
water and dry it with compressor air.
Notice:
do not damage the fin of the w/receiver condenser assy.
if a fin of the w/receiver condenser assy is bent, make it
straig ...
Inspection procedure
1 Check door lock
2 Check wire harness (tvip ecu door lock)
Disconnect the tvip ecu and door lock connectors.
check the continuity between the terminals of the tvip
ecu and door lock connectors, as shown in the illustration
and table.
Standard:
3 Check wire harness ...