Toyota Corolla (E210): Adding the washer fluid

Add washer fluid in the following situations:

  • A washer does not work.
  • The warning message appears on the multi-information display.

WARNING

WARNING

■When adding washer fluid

Do not add washer fluid when the engine is hot or running as washer fluid contains alcohol and may catch fire if spilled on the engine, etc.

NOTICE

■Do not use any fluid other than washer fluid

Do not use soapy water or engine antifreeze instead of washer fluid.

Doing so may cause streaking on the vehicle's painted surfaces, as well as damaging the pump leading to problems of the washer fluid not spraying.

■Diluting washer fluid

Dilute washer fluid with water as necessary.

Refer to the freezing temperatures listed on the label of the washer fluid bottle.

    Share this page:

    Other materials:

    Overhaul
    1. Drain clutch fluid 2. Disconnect clutch release cylinder to flexible hose tube Using sst, disconnect the flexible hose tube. Sst 09023–00100 Hint: use a container to catch the fluid. 3. Remove clutch release cylinder assy Remove the 3 bolts, clutch release cylinder assy ...

    Overhaul
    1. Remove manual transmission filler plug Remove the manual transmission filler plug and gasket from the manual transmission case. 2. Remove drain (mtm) plug sub–assy Remove the drain (mtm) plug sub–assy and gasket from the manual transmission case. 3. Remove speedomete ...

    Inspection procedure
    1 Check front airbag sensor (lh) circuit (to b+)(airbag sensor assy center – airbag sensor front lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the airbag ...