Toyota Corolla (E210): Using the storage features

Share this page:

Other materials:

Dtc check/clear
Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

Checking and adding the brake fluid
■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reservoir cap. 4. Add brake fluid slowl ...

Things you should know
■ If you notice any symptoms If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check. If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer. CAUTION ■When using the rear view monitor system ...