Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / O/d cancel signal circuit / Circuit description
Toyota Corolla (E120): Circuit description
While driving uphill with cruise control activated, in order to minimize gear shifting and provide smooth cruising overdrive may be prohibited temporarily under some conditions.
The cruise control ecu sends o/d cut signals to the ecm as necessary and the ecm cancels overdrive shifting until these signals are discontinued.
Wiring diagram

Other materials:
Circuit description
The rotary solenoid type idle air control (iac) valve is located
under the throttle body and intake air bypassing the throttle
valve flows into the iac valve through the passage.
In this way the intake air volume bypassing the throttle valve is
regulated, controls the engine speed.
The ...
Check short circuit
If the wire harness is ground shorted as shown in fig. 5,
Locate the section by conducting a resistance check with
the body ground in step (b).
Check the resistance with the body ground.
Disconnect connectors a and c and measure the
resistance between terminals 1 and 2 ...
Cruise control
The vehicle can be driven at
a set speed even if the
accelerator pedal is not
depressed.
Use the cruise control only
on highways and expressways.
WARNING
■For safe use
Driving safely is solely the
responsibility of the driver.
Therefore, do not overly rely on
this system. The driver is solel ...


