Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / O/d cancel signal circuit
Toyota Corolla (E120): O/d cancel signal circuit
Other materials:
Circuit description
Refer to dtc p0130
Dtc no.
Dtc detection condition
Trouble area
P0133
After engine has been warmed up, if response time that heated
oxygen sensor’s output voltage reaches from rich to lean.
Or from lean to rich, is 0.6 Second or more during idling.
...
Seat belt warning lamp for driver’s seat does not
operate
Wiring diagram
Inspection procedure
1 Check combination meter assy
Ground terminal c9–12 on the combination meter side.
check that the warning lightlights up.
Ok: warning light lights up.
2 Inspect front seat inner belt assy lh
Disconnect the front seat inner belt ...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...